Need more help? Click here to schedule a service call
This information assumes you do not have the GUI administration tool. To find more information on the GUI administration tool click here.
Button to the
right of the 3 on the keypad = Feature
From Phones on port 1 or port 2 only
Changes ALL DISPLAY phones
1. DO NOT LIFT THE HANDSET:
2. Press the Transfer button
3. Press the Conf button
4. Press the * key on the keypad
5. Press the Transfer button
6. Press the Conf button
7. Press the # key on the keypad
The Feature, Conf, & Speaker lights will be on
CAT MODE will be displayed on the screen
If there is confusion at any time, lift the handset and
hangup
8. Press the Redial button (COMMAND= will be
displayed on the screen)
9. Press 02 on the keypad
10. Press the Recall button
11. Press 2 on the keypad
12. Press the Recall button
13. Enter the time: HHMMSS (two digit - Hours,
Minutes, Seconds - Military time)
14. If a mistake is made, press Hold to erase the last
entry
15. Once finished, press the Conf button to make your
changes final
16. Lift the handset, and hangup
17. The new time will display within the next minute
We hope you
find these tips and tricks helpful. These documents
should provide sufficient information to program a Cremer
Technologies programmed system. Cremer Technologies takes
no responsibility for any problems arising from a
customer attempting to administer their via system
programing.