Need more help? Click here to schedule a
service call
This
information assumes you do not have the GUI
administration tool. To find more information on the
GUI administration tool click
here.
Button to the right of the 3
on the keypad = Feature
From ANY DISPLAY phone
1. DO NOT LIFT THE HANDSET:
2. Press the Transfer button
3. Press the Conf button
4. Press the * key on the keypad
5. Press the Transfer button
6. Press the Conf button
7. Press the # key on the keypad
The Feature, Conf, &Speaker lights will be on
CAT MODE will be displayed onthe screen
If there is confusion at any time, lift the handset and
hangup
8. Press the Redial button (COMMAND= will be
displayedon the screen)
9. Press 720 on the keypad
If "Digit Error" is displayed, press ANS , then press 72
10. Press the Recall button
11. Press the memory location code XXX (000 - 299)
12. Press the Recall button (display will show 720>XXX
: 9-)
13. Press the Recall button again to show the phone
number
14. To change ANY location, press the Answer button
15. Press the memory location code XXX (000 - 299)
16. Press the Recall button
( Dial the new phone number, starting with 9 Transfer
"comma" )
17. If a mistake is made, press Hold to erase the last
entry
18. Once finished, press the Conf button to make your
changes final
19. To change another, go to step 14
20. Lift the handset, and hangup.
We hope you
find these tips and tricks helpful. These documents
should provide sufficient information to program a Cremer
Technologies programmed system. Cremer Technologies takes
no responsibility for any problems arising from a
customer attempting to administer their via system
programing.